Fig. 1. Sixty-nine pounds of purple suede |
I played through it for a a few minutes, of course, and the reverb was definitely on and turned up, but not audible. I tapped the tank and could hear the springs rattling around through the speaker, so the output side (black cable in Fig. 2) was good. I swapped the cable for some good ones and it still didn't work.
Fig. 2. The white cable is connected to the input jack on the reverb tank, and the black cable is connected to the output. |
Fig. 3. The culprit: a loose wire that somehow got disconnected from the plastic connector on the left. (The cream-colored block under it is the input transducer) |
I tested again, and it worked fine. I put everything back together and took my tools down to the workshop, which sure beat having to lug this beast.
No comments:
Post a Comment